Garage Unique Front Lip Install Guide – Civic Type R FL5
Install Guide · Honda Civic Type R FL5
Garage Unique Front Lip
A direct bolt-in for the FL5's lower front bumper — no cutting, drilling into the body, or permanent modification required.
What You'll Need
- Phillips or Torx screwdriver (or drill/driver with matching bit)
- Painter's or masking tape
- Isopropyl alcohol wipes
- An extra set of hands for alignment
Installation Steps
1
Prep the Mounting Surface
Park on level ground and let the front end cool if just driven. Wipe the lower bumper section with a panel-safe cleaner to clear grime, wax, or polish residue.
2
Dry-Fit and Align
Have a helper hold the lip against the bumper. Tape it temporarily at a few points and check the gap is even left-to-right before committing to fasteners.
3
Fasten the Lip
Drive the included hardware through the lip's pre-drilled holes directly into the bumper plastic — work from the center outward toward each end.
4
Finish Up
Pull the alignment tape, wipe the center section with alcohol, apply the included badge, and press firmly for a few seconds to set the adhesive.
Don't use the OEM mounting tabs
They're not built to carry a bolt-on lip long-term — the lip's own pre-drilled holes are positioned specifically to bypass them. Every mounting point sits hidden behind the lip once installed.
Installation Checklist
- Lower bumper cleaned and free of grime or wax
- Lip dry-fit and taped with an even gap both sides
- All hardware through the lip's pre-drilled holes, not the OEM tabs
- No visible screws from the front or underneath
- Alignment tape removed and lip wiped with alcohol
- Badge applied and pressed firmly to set
Questions about fitment or your order? Reach out anytime at contact@eurowerks.co.